Hi,
I was hoping someone out there in SAP land could help us. We have read through all the notes and SCN discussions and are getting mixed messages on the answer to these questions.
1. Can a single connector be put into more than one connector group? For example, can an ECC PRD connector be put into a logicial group by itself and a cross-system group with another PRD connector?
2. If we designate a function as cross system will the risks associated with it only report conflicts between more than one system? For example, Risk ID F001 is comprised of AP01 and AR01.
AP01 contains action VA01.
AR01 contains action FB02.
VA01 exists in ECC and MDM.
AR01 exists in ECC.
If function AP01 is marked for cross system analysis will risk analysis ONLY shows cross-system risks that pertain to the function or will it also include a risk that occurs within ECC only (as in the above example)?
Also, if risk analysis automatically runs for ARM will it take cross-system into account?
Any help would be greatly appreciated!
Thanks,
Tracy